Comdial FX Series Especificaciones descargar pdf (Pagina 75)

At sites served by DID line blocks, installers must enable those lines for CFOS capability but they

do not associate the individual lines with specific CFOS-enabled stations. The system uses the DID

translated station extension to check for the station’s CFOS forwarding ability.

When another station transfers a call to a CFOS-enabled station, the feature does not require a line

association with the CFOS-enabled station for it to forward the transferred call outside the system. In

this case, the system identifies the CFOS-enabled station before it makes the transfer.

In addition to the line programming action discussed previously, installers enable CFOS

system-wide with a system programming choice. They then enable the feature in both station class of

service and individual station programming, and may map a CFOS button on the applicable

telephones. When mapping the button using VMMI, installers can also select CFOS options for the

station CFOS button along with a destination number; however, any user selected destination

number overrides this selection.

Comdial has taken reasonable steps in the design of all product features, including CFOS, which

protect against unauthorized or fraudulent access to, or use of, a system, or which protect against

unauthorized, fraudulent or unaccounted-for access to, or use of, long distance lines. However, no

system is entirely invulnerable or immune from unauthorized or fraudulent access or use, or

unaccounted-for access or use, and therefore Comdial disclaims any and all liability, and makes no

warranty, express or implied, relating to unauthorized or fraudulent access or use, or

unaccounted-for access or use.

NOTE: (1) CFOS will not work on loop start lines without disconnect supervision.

(2) Calls forwarded through CFOS may experience lower audio levels due to the normal line

resistance of CO lines. Low audio level is usually only noticeable on long line loops. If signal

loss is a problem at a particular site, the installer may need to add a line amplifier (repeater) in

the lines.

The Call Forward Outside System (CFOS) feature also includes forwarding outside of the system for

direct and transferred personal intercom calls. Also, the feature provides ring no–answer (RNA)

capability to the CFOS of both line and personal intercom calls. With this RNA capability, the

system rings a station a programmed number of rings and then forwards the call outside the system

based upon the programmed CFOS setting. Any restrictions that the CFOS feature currently imposes

on forwarded calls applies to forwarded personal intercom calls as well.

Call Forward, Recall

If the site includes ExecuMail equipment and the installer has arranged for the ExecuMail to provide

release transfer, she or he should also arrange for the ExecuMail station to have this call forward,

recall feature. Also see the discussion titled Call Forward—Busy or Ring No-Answer, All Or

Personal.

Call Forward to Hunt Groups

The Call Forward to Hunt Groups feature allows users to forward their intercom calls to hunt group

pilot numbers.

To enable this feature, first select the Intercom Forward To ... button on the STATIONS/STATION

PROGRAMMING/OPTIONS 1 menu. If the database contains station hunting groups, the VMMI

includes the pilot numbers for these groups as valid programming selections.

Understanding the Features – 71

General Description GCA40–242

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 171 172

Comdial FX Series Especificaciones Pagina 75

Comentarios a estos manuales

Comdial FX Series Especificaciones Pagina 75

Comentarios a estos manuales

Relacionado con productos y manuales para Contestadores automáticos Comdial FX Series