Comdial FX Series Especificaciones descargar pdf (Pagina 69)

You can program the system for any one of three different dial tones that you will hear whenever

you enter the ARS access code. The ARS dial tone choices are:

•

Dial Tone 1—steady intercom dial tone (dual tones of 480 Hz + 620 Hz),

•

Dial Tone 2—same as dial tone 1 only preceded by three short tones (200 ms on, 200 ms off),

•

Dial Tone 3—steady simulated central office ring back tone (dual tones of 440 Hz + 480 Hz).

Automatic Route Selection For Speed Dials

The installer can arrange for the system to route the system speed dial and any personal speed dial

numbers that the user has programmed through the system’s automatic route selection feature

(ARS).

ARS Access Per line Group

This feature allows the access code for any line group in the system to provide access to ARS. By

default, the line group 1 access code will provide ARS access when ARS is enabled. You can

program this item on a line group parameter.

ARS Delayed Dialtone

This feature adds a delay option for ARS Dialtone (Dial Tone 4). When the telephone user selects an

outside line, there is a 1 second delay before dial tone is presented to the caller. The dial tone

frequency is the same as the system intercom dial tone, but the delay gives the impression a “fresh”

dial tone for outbound dialing.

Restrict ARS Hookflash (Automatic Route Selection, Hookflash Restriction)

This feature enhances ARS response to hookflash action on an outside line when that action is

followed by dialed digits. With the feature enabled, the system delays response to a hookswitch flash

until after the ARS feature verifies as valid all subsequent dialed digits. With the feature disabled,

the system sends the hookflash over the line without waiting for the ARS feature to verify the

validity of subsequent dialed digits. This station class of service feature is applicable only when the

ARS feature is active.

Automatic Station Relocation

The system will automatically recognize a particular station should someone relocate it to a different

station port. After being installed at a new port location, a relocated station will provide the same

class of service parameters and station features that it provided at its original port location. Also, the

relocated station will respond to the same personal intercom number that it responded to at its

original port location. A relocated station prompts the user to take action to either accept its original

programming or accept the programming at the new port. If the user takes no action, the station

assumes the parameters and personal intercom number that is determined by a system programming

procedure. Consider these following points when you enable station relocation:

•

if someone does a station relocation, the installer must save the database programming to

make the relocation permanent,

Understanding the Features – 65

General Description GCA40–242

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 171 172

Sin comentarios

Comdial FX Series Especificaciones Pagina 69