
Attendant Features
LCD Message Creation
When you are busy or are away from your desk, you can set a message at your
telephone that will be received by any LCD speakerphone within your system.
Your system provides two default messages: “Back at...”and“Call...”In
addition, you can add eight customized messages for system wide use, or you can
create up to ten messages if you choose not to use the two default messages.
·
To store the LCD messages,
1. WRITE your messages on the chart on page 87 (each message
can have up to 16 characters).
2. USE the letter code table on page 87 to assign a number to each
letter.
3. WRITE these numbers on the chart line beside the message
letters.
4. PRESS INTERCOM.
5. DIAL
*#05.
6. DIAL a message location number (
1 , 2 , 3 , etc.).
7. DIAL
# to clear current message.
8. COMPOSE your messages by dialing the two-digit codes that re
-
late to the letters.
9. DIAL
* to save message.
10. REPEAT steps 6 through 9 until all messages are stored.
11. PRESS SPEAKER to end.
Attendant Manual - DSU II Digital Expandable System 85
GCA70-245 Attendant Features
8
Comentarios a estos manuales