Comdial Impact FXS Manual de usuario descargar pdf (Pagina 19)

Programming For Network DSS/BLF Support

Installers use the SYSTEM/NETWORKING menu to choose the Network Station Monitor item. Under

this heading, they can choose any node (but not the hub) system and configure the Send and Receive

monitor lists. Once the per node limit of 30 remote DSS/BLF appearances is reached, VMMI prevents

the addition of further remote appearances.

Under STATIONS/STATION PROGRAMMING/BUTTON MAPPING, installers select the station to

receive remote DSS/BLF appearance. Under the appropriate button map LKEY, they type the R####

mnemonic, for an extension on the far node (for example, type R2002 if 2002 is a far node extension).

Installers can select the Browse button to view a list of valid far node extensions to choose from.

Installers may button map a remote extension to any telephone in the network. If the remote extension is

not in the Receive list for the node the telephone resides on, the DSS button functions as a speed dial

button.

Ten Node Networking

Beginning with Software Release 170, Installers can program and configure up to 10 Nodes in addition

to the Hub to comprise a networking system. Previously the limit was 6 network nodes.

Under NETWORKING/NODE CONFIGURATION, NETWORKING/ NETWORK LINKS,

NETWORKING/EXTENSION PROVISIONING/ADD NODE EXTENSIONS, and

NETWORKING/EXTENSION PROVISIONING/REMOVE NODE EXTENSIONS, the number of

selectable nodes is 10 nodes.

Transfer To Voice Mail

With the networking status enabled, the system reserves voice mail port 32 for centralized voice mail on

the hub. This parameter has the following two consequences:

•

Installers must not use voice mail port 32 for local node voice mail when networking status is active.

The system ignores any parameters programmed for that port.

•

Installers must use port 32 for a Transfer to Voice Mail button whenever that button is planned to

cause a transfer to centralized voice mail to occur.

Programming For The Transfer To Voice Mail Networking Feature

The VMMI programming software allows installers to program XVM32 in a station’s button map to

create a button that will transfer to centralized voice mail. Additionally, VMMI will not allow installers

to program voice mail port 32 in a networking database.

If installers use VMMI to translate a networking database to Release 170 or later (from an earlier

revision), or when they enable networking in a Release 170 or later database, VMMI removes any

programming from voice mail port 32. Further, VMMI changes the forwarding location of any voice

mail port that had been previously forwarded to port 32 to the new port 32 forward-to location.

16 – System Networking Feature Enhancements

(Stand Alone Feature)

GCA40–219 Explaining The Software Release Features

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 25 26 27

Sin comentarios

Comdial Impact FXS Manual de usuario Pagina 19